Horizontal base curved [Digital File]

Included Versions:

1. Simple

2. With base for a standard plaque

3. With base for an extended autograph plaque

• Standard plaque: 3.5" x 1.5" (89 x 38 mm)
• Autograph plaque: 6.5" x 1.5" (165 x 38 mm)

Note: Plaques are not included.

Printing Recommendations:

• Print in a vertical position with supports only on the curved bottom section (from the outside), as some printers may struggle with that small curve.
• Recommended infill: minimum 25% for good weight
• PLA or PETG work well
• Maximum layer height: 0.2 mm
• Minimum: 3 walls, 3 top layers, and 3 bottom layers

Note: By purchasing this, you agree that these files are for personal use only. You are not authorized to sell 3D prints of these files.