Clan Saber Series 6 Chassis [Digital File]

This is a 3D file for home printing of the chassis to install one of the Clan Saber Series 6 

There are 2 sides A & B. The B side goes on the B side hilt with the covertec wheel. The set contains Side A & B chassis, board cover and blade PCB connector puck files. 

Printing Recommendations:

• Print it in a vertical position with supports only on the curved section at the bottom (from the outside), as some printers struggle with that small curve.
• I recommend a minimum infill of 25% to give it good weight.
• PLA or PETG work well.
• Maximum layer height: 0.2 mm.
• At least 3 walls, 3 bottom layers, and 3 top layers.

NOTE: By purchasing this file, you agree that it is for personal use only. You are not authorized to sell 3D prints of these files.